Sold Out

Replicator 2 Heated Build Plate

$ 459.00

This product is unavailable

About the Replicator 2 Heated Build Plate

Fully heated aluminum build plate for the Makerbot Replicator 2 printer, complete with on/off timer unit and temperature controller.  Print up to 130°C with this heated build plate.  Help your PLA prints stick better and eliminate curling, or better yet experiment with ABS, Nylon, Carbon Fiber, and other exotic materials.  

Installs in a couple minutes (instructions below) requiring NO TOOLS. Unit is completely wired, ready to plug-in and go. Our heated build plate system is completely independent and does not interface with the motherboard or power supply of the Replicator 2, so there is no soldering required.

A 250W silicone heater drives heat into the 1/4" thick aluminum plate which is flat within .05mm for the ultimate printing experience. Comes preinstalled with a layer of blue tape, or you can install kapton or your print surface of choice on top of this.

Note: It is highly recommended to use this product with reinforced aluminum arm stiffeners (to prevent bed sagging). Bundle with the heated build plate and save.

Installation & Operating Instructions

Download